Vinyl Lettering Application
Your quote sheet comes as pre-spaced letters made up
of 3 layers:
top layer = transfer paper (through which you can see the
letters)
middle layer = the letters themselves
bottom layer = white and shiny backing paper with grid on back
To apply:
1)
Prepare the surface
for the lettering. Dust or wash the area so you have a clean area to
adhere the lettering. Make
sure it is completely dry. Measure
the area you are going to apply the letters to and make small reference
marks if needed to ensure the quote goes on straight.
Make a little dot on the center of your quote on the transfer
paper side and a dot in the center of the area you will be placing the
letters.
2)
Lightly rub over the
saying to make sure the saying is sticking to the transfer paper (it
sometimes separates in shipping).
Place it on a flat surface (table) with the backing paper (grid)
face up. Carefully peel
away the backing paper, while helping the letters to stick to the
transfer paper on
bottom—this takes a little finesse, but the end product is awesome!
3)
Place the quote on
your wall in the measured out area (or line up the dots if you made
them). Rub over the
lettering to securely adhere them to your wall—a soft plastic or wood
device, a credit card or popsicle stick works best. Work from the center
out on both sides and carefully smooth out any air bubbles
4)
Carefully peel off
the transfer paper to reveal your letters. On some surfaces, you will
need to help the vinyl separate from the transfer paper.
5)
ENJOY YOUR BEAUTIFUL
WALL DÉCOR!
Go Back to FAQ
